Snap together! September 30 2013
An exciting new development in our design process is the addition of snap-fit models. The glueless construction simplifies assembly, but requires pretty clean dimensional performance from your printer. If your printer is well calibrated and makes pretty good corners, these should work for you.
On models that use a dihedral clip, it is helpful
to attach the clip corner first, while holding the
dihedral hinge tightly closed, then slide the clip
all the way forward until it stops or clicks into place.
The stingray
The glueless stratos
These and more coming soon.... and don't worry, If you have recently purchased any of our "all models" sets, I will be forwarding the new designs to your emails when they are ready, free of charge!
In the mean time, the preview editions are availble at thingiverse....http://www.thingiverse.com/thing:158430 and http://www.thingiverse.com/thing:158421